PIM Commands
ip pim state-refresh-limit
Sets the limit at which a router will not forward successive State Refresh messages if they are received at
less than the interval.
ip pim state-refresh- limit ticks
Syntax Definitions
ticks
Defaults
parameter
ticks
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is supported only in the dense mode.
•
This value is used with both IPv4 and IPv6.
Examples
-> ip pim state-refresh-limit 2
Release History
Release 6.1.1; command was introduced.
Related Commands
ip pim interface
ipv6 pim interface
show ip pim dense
show ipv6 pim dense
MIB Objects
alaPimdmGlobalConfig
alaPimdmStateRefreshLimitInterval
OmniSwitch CLI Reference Guide
The limit at which the received State Refresh messages will not be
forwarded, if the messages are received at less than the interval. Values
may range from 0 to 65535.
default
0
Enables or disables the PIM protocol on a specific interface.
Enables IPv6 PIM and configures the statistics.
Displays the status of the various global parameters for the PIM
dense mode.
Displays the status of the various global parameters for the IPv6
PIM dense mode.
June 2012
page 30-27