Vlan Ipmvlan Sender-Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

vlan ipmvlan sender-port

Configures a port, a range of ports, an aggregate of ports, or a range of aggregates as sender port for the IP
Multicast VLAN. This sender port can receive multicast data for the configured multicast groups.
vlan ipmvlan ipmvlan-id sender-port {port slot/port[-port2] | linkagg agg_num [-agg_num2]}
no vlan ipmvlan ipmvlan-id sender-port {port slot/port[-port2] | linkagg agg_num [-agg_num2]}
Syntax Definitions
ipmvlan-id
slot/port
port2
agg_num
agg_num2
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove a single port, a range of ports, an aggregate of ports, or a
range of aggregates assigned as the sender port(s) for the IPMVLAN.
•
Multiple sender ports can be assigned to an IPMVLAN and a port can be configured as a sender port
for multiple IPMVLANs.
•
In the Enterprise mode, the configuration fails if the port configured as a sender port is not a tagged
port, or if the port is an aggregated port ( member port of a logical aggregate) or a VLAN Stacking
port.
•
In the VLAN Stacking mode, the configuration fails if the port configured as a sender port is not a
VLAN Stacking port (network port).
Examples
The following command configures the sender port in an Enterprise mode:
-> vlan ipmvlan 1003 sender-port port 1/45-50
The following commands configure the sender port in the VLAN Stacking mode:
page 28-8
Specifies the IP Multicast VLAN number to which the port will be
attached as a sender port. The valid range is 2–4094.
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
The link aggregate ID number (0–31) to be assigned as a sender port to
the IPMVLAN.
The last link aggregate ID number in a range of aggregates that you
want to configure.
IP Multicast VLAN Commands
OmniSwitch CLI Reference Guide June 2012