Ip Multicast Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IP Multicast Switching Commands

ip multicast status

Enables or disables IP Multicast Switching and Routing on the specified VLAN, or on the system if no
VLAN is specified.
ip multicast [vlan vid] status [{enable | disable}]
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
If an IP Multicast Routing protocol is already running on the system, the ip multicast status command
will override the existing configuration and always enable IP Multicast Switching and Routing.
•
If the IP Multicast Switching and Routing is already enabled on the system, then the VLAN configura-
tion will override the system's configuration.
•
You can also restore the IP Multicast Switching and Routing to its default (i.e., disabled) status on the
system if no VLAN is specified, by using only ip multicast status (e.g., ip multicast status).
•
You can also restore the IP Multicast Switching and Routing to its default (i.e., disabled) status on the
specified VLAN, by using only ip multicast vlan vid status (e.g., ip multicast vlan 2 status).
Examples
-> ip multicast status enable
-> ip multicast status disable
-> ip multicast status
-> ip multicast vlan 2 status enable
-> ip multicast vlan 2 status disable
-> ip multicast vlan 2 status
Release History
Release 6.1.1; command was introduced.
OmniSwitch CLI Reference Guide
VLAN on which to apply the configuration.
Enable IP Multicast Switching and Routing.
Disable IP Multicast Switching and Routing.
default
disable
June 2012 page 27-3