Ip Bgp Policy Prefix-List Le - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

BGP Commands

ip bgp policy prefix-list le

Configures the upper limit on the length of the prefix to be matched.
ip bgp policy prefix-list name ip_address ip_mask le value
Syntax Definitions
name
ip_address
ip_mask
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The default value of zero indicates there is no upper limit on the length of the prefix to be matched.
This command is used in conjunction with
range. The two commands can be combined, as show in the Example section below.
•
The ge (lower limit) value must be greater than or equal to the prefix length (8 in the example below)
and less than or equal to the le (upper limit) value.
Examples
-> ip bgp policy prefix-list prefixListA 14.0.0.0 255.0.0.0 ge 8 le 16
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Prefix list name.
Prefix list IP address for the prefix list.
Prefix list mask for the prefix list.
The upper limit value in the range of 0 to 32.
default
0
ip bgp policy prefix-list ge
June 2012
to set the prefix matching
page 25-117