IP Multicast Switching Commands
ipv6 multicast unsolicited-report-interval
Sets the MLD unsolicited report interval on the specified VLAN or on the system if no VLAN is speci-
fied.
ipv6 multicast [vlan vid] unsolicited-report-interval [seconds]
Syntax Definitions
vid
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
IPv6 Multicast Switching and Routing must be enabled to set the MLD unsolicited report interval to
use on the system and/or the specified VLANs.
•
If the MLD unsolicited report interval is already configured on the system, then the VLAN configura-
tion will override the system's configuration.
•
The unsolicited report interval refers to the time period to proxy any changed MLD membership state.
•
To restore the MLD unsolicited interval to its default (i.e., 1 second) value on the system if no VLAN
is specified, use ipv6 multicast unsolicited-report-interval followed by the value 0 (e.g., ipv6 multi-
cast unsolicited-report-interval 0) or use only ipv6 multicast unsolicited-report-interval (e.g., ipv6
multicast unsolicited-report-interval).
•
To restore the MLD unsolicited report interval to its default (i.e., 1 second) value on the specified
VLAN, use ipv6 multicast vlan vid unsolicited-report-interval followed by the value 0 (e.g., ipv6
multicast vlan 2 unsolicited-report-interval 0) or use only
ipv6 multicast vlan vid unsolicited-report-interval (e.g., ipv6 multicast vlan 2 unsolicited-report-
interval).
Examples
-> ipv6 multicast unsolicited-report-interval 20000
-> ipv6 multicast unsolicited-report-interval 0
-> ipv6 multicast unsolicited-report-interval
-> ipv6 multicast vlan 2 unsolicited-report-interval 20000
-> ipv6 multicast vlan 2 unsolicited-report-interval 0
-> ipv6 multicast vlan 2 unsolicited-report-interval
OmniSwitch CLI Reference Guide
VLAN on which to apply the configuration.
MLD unsolicited report interval in seconds. Valid range is 1 to 65535,
where 0 represents the default setting.
default
1
June 2012
page 27-69