Ip Pim Rp-Threshold - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

PIM Commands

ip pim rp-threshold

Specifies the data rate, in bits per second (bps), at which the Rendezvous Point (RP) will attempt to switch
to native forwarding by issuing a source-specific (S, G) Join message toward the source.
ip pim rp-threshold bps
Syntax Definitions
bps
Defaults
parameter
bps
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is supported only in the sparse mode.
•
To disable the RP threshold feature, specify a bits per second value of 0. When the RP threshold is
disabled, the RP will never initiate an (S, G) Join message toward the source; the packets will be
register-encapsulated to the RP. It will issue a (S, G) Join message upon receiving the first data packet,
if its bits per second value is 1.
•
To view the current RP threshold, use the
Examples
-> ip pim rp-threshold 131072
Release History
Release 6.1.1; command was introduced.
Related Commands
show ip pim sparse
MIB Objects
alaPimsmGlobalConfig
alaPimsmRPThreshold
OmniSwitch CLI Reference Guide
The data rate value, in bits per second, at which the RP will attempt to
switch to native forwarding (0–2147483647).
default
1
show ip pim sparse
Displays the global parameters for PIM sparse mode.
June 2012
command.
page 30-17