Ipv6 Bgp Network Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ipv6 bgp network status

Enables or disables a BGP
BGP neighbor and network parameters.
ipv6 bgp network ipv6_address/prefix_length [status {enable | disable}]
Syntax Definitions
ipv6_address
/prefix_length
enable
disable
Defaults
By default, the BGP network is disabled.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
The IPv6 BGP route created with the
is defined.
Examples
-> ipv6 bgp network 2001::1/64 status enable
Release History
Release 6.1.5; command was introduced.
Related Commands
show ipv6 bgp network
MIB Objects
alaBgpNetwork6Table
alaBgpNetwork6Addr
alaBgpNetwork6MaskLen
alaBgpNetwork6RowStatus
page 25-212
network. The BGP status must be manually enabled after configuring all the
The 128-bit IPv6 address.
The number of bits that are significant in the IPv6 address (mask)
(3..128).
Enables the BGP network.
Disables the BGP network.
ipv6 bgp network
Displays the status of all the IPv6 BGP networks or a specific IPv6
BGP network.
command should exist before the status attribute
OmniSwitch CLI Reference Guide
BGP Commands
June 2012