Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1494

•
If the encrypt-key parameter is used to configure the password through the CLI, then its value should
be the same as the one that appears in the configuration snapshot. Only valid system generated values
are accepted as encrypt-key.
•
This command also configures the authentication type and the corresponding key. These settings over-
ride the configuration done on the specific interface.
•
By default, the authentication is disabled and no authentication type is configured.
Examples
-> ip isis interface wan-50 level 1 hello-auth-type md5 key xyz123
-> ip isis interface man-80 level 2 hello-auth-type none
Release History
Release 6.2.1; command was introduced.
Related Commands
ip isis interface hello-auth-type
show ip isis interface
MIB Objects
vRtrIsisIfLevelTable
vRtrIsisIfLevelHelloAuthType
vRtrIsisIfLevelHelloAuthKey
page 24-72
Configures the authentication of Hello PDUs on a specific interface.
Displays the IS-IS interface information.
OmniSwitch CLI Reference Guide
IS-IS Commands
June 2012