Qos Port Trusted - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

qos port trusted

Configures whether an individual port is trusted or untrusted. Trusted ports can accept the 802.1p and ToS/
DSCP values in incoming packets; untrusted ports will set any 802.1p or ToS/DSCP values to zero in
incoming packets, unless a default 802.1p or ToS/DSCP value is configured.
qos port slot/port trusted
qos port slot/port no trusted
Syntax Definitions
slot/port
Defaults
By default, QoS ports are not trusted.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the qos trust ports
command may be used to override the default.
•
The setting applies only to ports with incoming traffic.
•
Use the qos port default 802.1p
zero should be applied to the incoming packets. Note that this value is overridden if a policy exists that
specifies a different 802.1p or ToS/DSCP value for such packets.
•
Mobile ports and ports configured for 802.1Q are always trusted.
Examples
-> qos port 3/1 trusted
-> qos port 4/2 no trusted
Release History
Release 6.1; command was introduced.
page 32-46
The slot number and port number of the physical port.
command to set the default trust mode for all QoS ports. The qos port trusted
or qos port default dscp commands to specify that a value other than
OmniSwitch CLI Reference Guide
QoS Commands
June 2012