Show Ip Bgp Network - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip bgp network

Displays currently defined network configurations.
show ip bgp network [network_address ip_mask]
Syntax Definitions
network_address
ip_mask
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
This command displays all the configured networks, or a single network.
Examples
-> show ip bgp network
Network
---------------+---------------+-----------+----------
155.132.1.2
155.132.1.3
-> show ip bgp network 155.132.1.2 255.255.255.255
Network address
Network mask
Network admin state
Network oper state
Network metric
Network local preference = 0,
Network community string = 0:500 400:1 300:2
output definitions
Network or Network address
Mask or Network mask
Admin state or
Network admin state
page 25-166
A 32-bit IP address.
A 32-bit subnet mask number that determines how many bits of the IP
address parameter denote the network number
Mask Admin state Oper state
255.255.255.255 disabled
255.255.255.255 disabled
= 155.132.1.2,
= 255.255.255.255,
= disabled,
= not_active,
= 0,
The IP address configured for this local BGP network. This value is
configured through the
The mask configured for this local BGP network. This value is config-
ured through the
Indicates whether this local BGP network is administratively enabled
or disabled. This value is configured through the
ip bgp network status
not_active
not_active
ip bgp network command.
ip bgp network command.
command.
OmniSwitch CLI Reference Guide
BGP Commands
June 2012