Ip Multicast Querying - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip multicast querying

Enables or disables IGMP querying on the specified VLAN or on the system if no VLAN is specified.
ip multicast [vlan vid] querying [{enable | disable}]
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
IP Multicast Switching and Routing must be enabled to enable IGMP querying on the system and/or
specified VLANs.
•
If the IGMP querying is already enabled/disabled on the system, then the VLAN configuration will
override the system's configuration.
•
IGMP querying refers to requesting the network's IGMP group membership information by sending out
IGMP queries. IGMP querying also involves participating in IGMP querier election.
•
You can also restore the IGMP querying to its default (i.e., disabled) setting on the system if no VLAN
is specified, by using only ip multicast querying (e.g., ip multicast querying).
•
You can also restore the IGMP querying to its default (i.e., disabled) setting on the specified VLAN, by
using only ip multicast vlan vid querying (e.g., ip multicast vlan 2 querying).
Examples
-> ip multicast querying enable
-> ip multicast querying disable
-> ip multicast querying
-> ip multicast vlan 2 querying enable
-> ip multicast vlan 2 querying disable
-> ip multicast vlan 2 querying
page 27-34
VLAN on which configuration is applied.
Enable IGMP querying.
Disable IGMP querying.
default
disable
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide June 2012