Ip Bgp Policy Community-List Action - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip bgp policy community-list action

Configures the action to be taken for a community list when a match is found.
ip bgp policy community-list name {none | no-export | no-advertise | no-export-subconfed | num:num}
action {permit | deny}
Syntax Definitions
name
none
no-export
no-advertise
no-export-subconfed
num:num
permit
deny
Defaults
parameter
permit | deny
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
By default, this command allows routes that match the criteria specified in the community list to pass.
Examples
-> ip bgp policy community-list commListAIn 600:1 action permit
-> ip bgp policy community-list commListAIn 600:1 action deny
Release History
Release 6.1; command was introduced.
page 25-106
Community name, e.g., CommListAIn, ranging from 0 to 70 characters,
or a value of none. The Community name is case sensitive.
Removes the community restrictions on the community section of the
route map.
Routes in this community are advertised within the AS but not beyond
the local AS.
Routes in this community are not advertised to any peer.
Routes in this community are not advertised to any external BGP peer.
The community number, given in the form of the AS number and the
community number, separated by a colon, as defined in RFC 1997.
Allows matching routes to pass.
Stops matching routes from passing.
default
permit
OmniSwitch CLI Reference Guide
BGP Commands
June 2012