Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2027

PIM Commands
Related Commands
ip pim sparse status
ip pim interface
ip pim keepalive-period
ip pim max-rps
ip pim probe-time
ip pim register checksum
ip pim register-suppress-
timeout
ip pim rp-threshold
ip pim spt status
MIB Objects
alaPimsmGlobalConfig
alaPimsmAdminStatus
alaPimKeepalivePeriod
alaPimsmMaxRPS
alaPimsmProbeTime
alaPimsmOldRegisterMessageSupport
alaPimRegisterSuppressionTime
alaPimsmRPThreshold
alaPimsmAdminSPTConfig
OmniSwitch CLI Reference Guide
Globally enables or disables PIM-SM protocol on the switch.
Enables or disables the PIM protocol on a specific interface.
Configures the period during which the (S,G) Join state will be
maintained in the absence of (S,G) Join messages or explicit (S,G)
local membership.
Configures the maximum number of C-RP routers allowed in the
PIM-SM domain.
Configures the amount of time before the Register Suppression
timer expires, at which point the Designated Router (DR) sends a
Null Register message to the Rendezvous Point (RP). This allows
the RP to refresh the Register-Stop. If the Register Suppression
timer expires, the DR will resume encapsulating packets from the
source to the RP.
Configures the application of the checksum function on sent and
received register messages in the domain.
Specifies the period during which a Designated Router (DR) stops
sending Register-encapsulated packets to the Rendezvous Point
(RP) after receiving a Register-Stop message.
Specifies the data rate, in bits per second (bps), at which the Ren-
dezvous Point (RP) will attempt to switch to native forwarding by
issuing a source-specific (S, G) Join message toward the source.
Enables or disables last hop Designated Router (DR) switching to
the Shortest Path Tree (SPT). If enabled, last hop DR switching to
the SPT begins once the first data packet is received.
June 2012 page 30-39