Qos Apply - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Commands

qos apply

Applies configured global QoS and policy settings to the current configuration (changes will be active and
stored in flash).
qos apply
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command is required to activate all QoS and policy commands. This is the only command that
causes current changes to be written to flash.
•
Rules are configured through the policy rule command, but are not active on the switch until you enter
qos apply.
Examples
-> qos apply
Release History
Release 6.1; command was introduced.
Related Commands
qos revert
qos reset
qos flush
MIB Objects
alaQoSConfigTable
alaQoSConfigApply
OmniSwitch CLI Reference Guide
Removes any policies configured through policy rule but not applied to
the current configuration through the qos apply command.
Resets the QoS configuration to its default values.
Deletes all pending policy information.
June 2012 page 32-37