Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1973

DVMRP Commands
output definitions (continued)
Number of Routes
Number of Reachable Routes
Release History
Release 6.1; command was introduced.
Related Commands
ip dvmrp status
ip dvmrp flash-interval
ip dvmrp graft-timeout
ip dvmrp neighbor-timeout
ip dvmrp prune-lifetime
ip dvmrp prune-timeout
ip dvmrp report-interval
ip dvmrp route-holddown
ip dvmrp route-timeout
ip dvmrp subord-default
MIB Objects
alaDvmrpConfigMIBGroup
alaDvmrpAdminStatus
alaDvmrpRouteReportInterval
alaDvmrpFlashUpdateInterval
alaDvmrpNeighborTimeout
alaDvmrpRouteExpirationTimeout
alaDvmrpRouteHoldDown
alaDvmrpNeighborProbeInterval
alaDvmrpPruneLifetime
alaDvmrpPruneRetransmission
alaDvmrpGraftRetransmission
alaDvmrpInitNbrAsSubord
dvmrpGeneralGroup
dvmrpNumRoutes
dvmrpReachableRoutes
OmniSwitch CLI Reference Guide
The number of entries in the routing table. This number can be used to
monitor the routing table size and detect illegal advertisements of uni-
cast routes.
The total number of reachable routes. The number of entries in the rout-
ing table with non-infinite metrics. This number can be used to detect
network partitions by observing the ratio of reachable routes to total
routes. Routes with unreachable metrics, routes in a holddown state,
and routes that have aged out are not considered reachable.
Globally enables or disables DVMRP protocol on the switch.
Configures the minimum flash update interval value.
Configures the graft message retransmission value.
Configures the neighbor timeout.
Indicates the length of time a prune will be in effect.
Configures the prune packet retransmission value.
Configures the route report interval.
Configures the time during which DVMRP routes are kept in a hold
down state.
Configures the route expiration timeout value.
Configures the neighbor probe interval time.
June 2012 page 29-27