Show Ip Dvmrp Interface - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip dvmrp interface

Displays information for all multicast-capable interfaces or for a specified interface. This command also
provides options to display only DVMRP-enabled or DVMRP-disabled interfaces.
show ip dvmrp interface [ip_address | interface_name | enabled | disabled]
Syntax Definitions
ip_address
interface_name
enabled
disabled
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
If no optional syntax is specified in the command line, the entire interface table is displayed.
•
For an interface to show as enabled in the show ip dvmrp interface or show ip dvmrp interface
enabled output, the interface must be both administratively and operationally enabled. Although the
interface does not have to be passing traffic, at least one VLAN router port must be operational on the
corresponding DVMRP-enabled VLAN.
•
To view the Generation ID being used on a particular interface, you must include the interface IP
address in the command line.
Examples
-> show ip dvmrp interface
Interface Name
---------------------+-----+--------+-------------+-------------
vlan-1
vlan-2
-> show ip dvmrp interface enabled
Interface Name
---------------------+-----+--------+-------------+-------------
vlan-2
page 29-28
Specifies a particular interface IP address.
The name of the interface.
Displays a list of all interfaces (i.e., VLAN router ports) on which
DVMRP is currently enabled.
Displays a list of all interfaces (i.e., VLAN router ports) on which
DVMRP is currently disabled.
Vlan Metric Admin-Status
1 1 Disabled
2 1 Enabled
Vlan Metric Admin-Status
2 1 Enabled
Oper-Status
Disabled
Enabled
Oper-Status
Enabled
OmniSwitch CLI Reference Guide
DVMRP Commands
June 2012