Ipv6 Multicast Proxying - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IP Multicast Switching Commands

ipv6 multicast proxying

Enables or disables MLD proxying on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] proxying [enable | disable]
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
If the MLD proxying is already enabled on the system, then the VLAN configuration will override the
system's configuration.
•
MLD proxying refers to processing membership information on behalf of client systems and reporting
membership on their behalf.
•
You can also restore the MLD proxying to its default (i.e., disabled) setting on the system if no VLAN
is specified, by using only ipv6 multicast proxying (e.g., ipv6 multicast proxying).
•
You can also restore the MLD proxying to its default (i.e., disabled) setting on the specified VLAN, by
using only ipv6 multicast vlan vid proxying (e.g., ipv6 multicast vlan 2 proxying).
Examples
-> ipv6 multicast proxying enable
-> ipv6 multicast proxying disable
-> ipv6 multicast proxying
-> ipv6 multicast vlan 2 proxying enable
-> ipv6 multicast vlan 2 proxying disable
-> ipv6 multicast vlan 2 proxying
Release History
Release 6.1.3; command was introduced.
OmniSwitch CLI Reference Guide
VLAN on which to apply the configuration.
Enable MLD proxying.
Disable MLD proxying.
default
disable
June 2012 page 27-83