Ip Bgp Policy Route-Map Origin - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

BGP Commands

ip bgp policy route-map origin

Configures the action to be taken on the origin attribute when a match is found.
ip bgp policy route-map name sequence_number origin {igp | egp| incomplete | none}
Syntax Definitions
name
sequence_number
igp
egp
incomplete
none
Defaults
parameter
igp | egp| incomplete | none
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
By default, no action is taken on the origin attribute when a match is found. The default behavior can be
reset by changing the value to "none".
Examples
-> ip bgp policy route-map routemap1 1 origin egp
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Route map name.
Route map sequence number. Valid range 1–255.
Sets the origin attribute to remote internal BGP (IGP).
Sets the origin attribute to local external BGP (EGP).
Sets the origin attribute to incomplete, meaning the origin is unknown.
Sets the origin attribute to "none".
default
none
June 2012 page 25-143