Show Ip Isis Database - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IS-IS Commands

show ip isis database

Displays IS-IS LSP database information of the adjacent routers.
show ip isis database [{system_id system_id | lsp_id lsp_id}] [detail] [level {1 | 2}]
Syntax Definitions
system_id
lsp_id
detail
level
Defaults
By default the entire LSP database is displayed.
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
Use system-id or lsp-id parameter with this command to view specific LSP database information.
•
Use the level parameter with this command to view the LSP database information of a particular level.
Examples
-> show ip isis database
Legends : P
OV = The overload bit is set
ATT = The Attach bit is set
L1 = Specifies a Level 1 IS type
L2 = Specifies a Level 2 IS type
=================================================================
ISIS Database
=================================================================
LSP ID
------------------------------------------------------------------
Displaying level-1 database
------------------------------------------------------------------
1720.2116.0051.00-00
level-1 LSP count : 1
Displaying level-2 database
------------------------------------------------------------------
1720.2116.0051.00-00
level-2 LSP count : 1
=====================================================================
OmniSwitch CLI Reference Guide
The system ID of the router.
The LSP ID.
Indicates that the output is displayed in a detailed manner.
Indicates the IS-IS level, either 1 or 2.
= The Partition repair bit is set
Sequence Checksum
0x44 0xb664
0x45 0xb465
June 2012
Lifetime Attributes
919 L1L2
1083 L1L2
page 24-37