Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1970

Defaults
parameter
message_type
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to disable debugging for the specified item.
•
Reminder: Debugging for a specified message type will only be enabled if its debug level is a value
greater than zero (i.e., 1–255). For information on specifying the debug level, refer to the
ip dvmrp debug-level command on page
•
The syntax all can be used to easily turn debugging for all message types on or off
(e.g., ip dvmrp debug-type all or no ip dvmrp debug-type all).
Examples
-> ip dvmrp debug-type all
-> ip dvmrp debug-type tm igmp flash
-> no ip dvmrp debug-type misc
-> no ip dvmrp debug-type all
Release History
Release 6.1; command was introduced.
Related Commands
ip dvmrp debug-level
show ip dvmrp debug
MIB Objects
N/A
page 29-24
default
error
29-22.
Defines the level of debugging for DVMRP protocol on the switch.
Displays the current level of debugging for DVMRP protocol on the
switch, as well as the current status for all debugging types.
OmniSwitch CLI Reference Guide
DVMRP Commands
June 2012