BGP Commands
ip bgp aggregate-address metric
Configures the MED attribute value for a BGP aggregate. This value is used when announcing this aggre-
gate to internal peers; it indicates the best exit point from the AS.
ip bgp aggregate-address ip_address ip_mask metric value
no ip bgp aggregate-address ip_address ip_mask metric value
Syntax Definitions
ip_address
ip_mask
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to reset the aggregate metric back to its default value.
•
The default value of zero indicates that a MED will not be sent for this aggregate. When a MED value
is missing for a route, BGP will determine a MED value based upon the settings specified in the
bestpath med missing-as-worst
Examples
-> ip bgp aggregate-address 172.22.2.115 255.255.255.0 metric 0
-> no ip bgp aggregate-address 172.22.2.115 255.255.255.0 metric 0
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
A 32-bit IP address.
A 32-bit subnet mask that determines how many bits of the IP address
denote the network number.
The MED attribute. The valid range is 0–4294967295.
default
0
command.
June 2012
ip bgp
page 25-41