Show Ip Bgp Aggregate-Address - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip bgp aggregate-address

Displays aggregate route status.
show ip bgp aggregate-address [ip_address ip mask]
Syntax Definitions
ip_address
ip_mask
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
This command displays a specific aggregate address, or all aggregate addresses on the router.
Examples
-> show ip bgp aggregate-address
Network
---------------+---------------+---------+--------+-----------+----------
155.132.44.73
192.40.6.0
-> show ip bgp aggregate-address 192.40.6.0 255.255.255.255
Aggregate address
Aggregate mask
Aggregate admin state
Aggregate oper state
Aggregate as-set
Aggregate summarize
Aggregate metric
Aggregate local preference = 0,
Aggregate community string = 0:500 400:1 300:2
output definitions
Network or Aggregate address The IP address for this aggregate route. This value is configured
Mask or Aggregate mask
Summarize or
Aggregate summarize
page 25-164
The 32-bit IP address of the aggregate address.
The 32-bit subnet mask number that determines how many bits of the IP
address parameter denote the network number.
Mask Summarize As-Set
255.255.255.255 disabled
255.255.255.255 disabled
= 192.40.6.0,
= 255.255.255.255,
= disabled,
= not_active,
= disabled,
= disabled,
= 0,
through the
The mask for this aggregate route. This value is configured through the
ip bgp aggregate-address
Indicates whether aggregate summarization is enabled or disabled for
this aggregate route. This value is configured through the
aggregate-address summary-only
Admin state Oper state
disabled disabled
disabled disabled
ip bgp aggregate-address
command.
command.
OmniSwitch CLI Reference Guide
BGP Commands
not_active
not_active
command.
ip bgp
June 2012