Ipv6 Ospf Virtual-Link - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

OSPFv3 Commands

ipv6 ospf virtual-link

Creates or deletes a virtual link. A virtual link restores the backbone connectivity if the backbone is not
physically contiguous.
ipv6 ospf virtual-link area area_id router router_id
[dead-interval seconds] [hello-interval seconds] [retrans-interval seconds] [transit-delay seconds]
no ipv6 ospf virtual-link area area_id router router_id
Syntax Definitions
area_id
router_id
dead-interval seconds
hello-interval seconds
retrans-interval seconds
transit-delay seconds
Defaults
parameter
dead-interval seconds
hello-interval seconds
retrans-interval seconds
transit-delay seconds
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
OmniSwitch CLI Reference Guide
A unique 32-bit value in IP address format.
A unique 32-bit value, such as an IP address, that identifies a neighbor-
ing router in the Autonomous System.
Sets the virtual link dead interval. If no hello packets on this link for the
set number of seconds have been received, the virtual neighbor is
declared dead. The valid range is 1–2147483647.
Sets the virtual link hello interval, which is the time interval between
OSPF hellos sent on this virtual link. The valid range is 1–65535.
Sets the virtual link retransmit interval. The router waits the set number
of seconds before retransmitting OSPF packets. The valid range is
0–3600.
Sets the virtual link transit delay, which is the number of seconds to
transmit OSPF packets over this link. The valid range is 0–3600.
default
40
10
5
1
June 2012 page 23-11