Qos Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

qos port

Configures QoS parameters for a physical port. This section describes the base command with a single
required option (slot/port).
In lieu of these options, the base command (qos port) may be used with other keywords to set up a QoS
configuration on a per port basis. These keywords are listed here and described as separate commands later
in this chapter. In addition, some keywords have a no form to remove the parameter or return it to its
default.
qos port slot/port
[trusted]
[servicing mode]
[qn {minbw | maxbw} kbps]
[maximum egress-bandwidth]
[maximum ingress-bandwidth]
[default 802.1p value]
[default dscp value]
[default classification {802.1p | tos | dscp}]
[dei {ingress | egress}]
Syntax Definitions
slot/port
Defaults
•
Mobile ports and ports enabled for 802.1Q are always trusted; by default, any other ports are not
trusted.
•
By default, QoS ports do not preempt queues of lower priority.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Use the trusted option to change the trust mode for the port.
Examples
-> qos port 3/1 trusted
-> qos port 4/2 no trusted
Release History
Release 6.1; command was introduced.
page 32-44
The physical slot and port number. For example: 4/1.
OmniSwitch CLI Reference Guide
QoS Commands
June 2012