Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2029

PIM Commands
output definitions
Status
Source Lifetime
State Refresh Interval
State Refresh Limit Interval
State Refresh TTL
Release History
Release 6.1.1; command was introduced.
Release 6.3.1; join/prune field was removed.
Related Commands
ip pim dense status
ip pim interface
ip pim state-refresh-interval
ip pim state-refresh-limit
ip pim state-refresh-ttl
ip pim keepalive-period
MIB Objects
alaPimdmGlobalConfig
alaPimdmAdminStatus
alaPimKeepalivePeriod
alaPimRefreshInterval
alaPimdmStateRefreshLimitInterval
alaPimdmStateRefreshTimeToLive
OmniSwitch CLI Reference Guide
The current global (i.e., switch-wide) status of PIM-DM. Options
include enabled and disabled.
The duration of the Keepalive or Source Lifetime timer. The default
value is 210.
The time-interval, in seconds, between successive State Refresh mes-
sages originated by the router. The default value is 60.
Displays the limit at which a router will not forward the State Refresh
messages, if they are received at less than the interval.
Displays the TTL to be used in the router's originated State Refresh
messages. The default value is 16.
Globally enables or disables PIM-DM protocol on the switch.
Enables or disables the PIM protocol on a specific interface.
Sets the interval between successive State Refresh messages origi-
nated by a router.
Sets the limit at which a router will not forward successive State
Refresh messages if they are received at less than the interval.
Sets the Time to Live to be used in a router's originated State
Refresh messages if the data packet's Time to Live is not recorded.
Configures the period during which the (S,G) Join state will be
maintained in the absence of (S,G) Join messages or explicit (S,G)
local membership.
June 2012 page 30-41