ip load dvmrp
Dynamically loads DVMRP to memory.
ip load dvmrp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command must be executed before DVMRP can be configured on the switch. In addition,
DVMRP must be administratively enabled before you can run the protocol on the switch. For more
information, refer to the
•
The advanced routing image must be loaded before the DVMRP feature starts working on the switch.
Examples
-> ip load dvmrp
Release History
Release 6.1; command was introduced.
Related Commands
ip dvmrp status
MIB Objects
alaDrcTmConfig
alaDrcTmIPDvmrpStatus
page 29-2
ip dvmrp status command on page
Globally enables or disables DVMRP protocol on the switch.
29-3.
OmniSwitch CLI Reference Guide
DVMRP Commands
June 2012