Show Ip Slb Clusters - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip slb clusters

Displays the status and basic configuration for all Server Load Balancing (SLB) clusters on a switch. This
command also displays traffic statistics for QoS policy condition clusters.
show ip slb clusters [statistics]
Syntax Definitions
statistics
Defaults
By default, the status and basic configuration for all clusters is displayed; statistics are not shown.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 9000E
Usage Guidelines
Use the statistics parameter to display the total number of packets that were passed to clusters because
they met the QoS condition criteria configured for that cluster. The polling interval used to obtain such
statistics is every 15 minutes. See the second example below.
Examples
-> show ip slb clusters
Cluster Name
----------------+----------------+--------+-------------------+-----+---------
WorldWideWeb
Intranet
FileTransfer
Output fields are described here:
output definitions
Cluster Name
VIP/COND
Admin Status
Operational Status
# Srv
% Avail
page 26-34
Displays SLB statistics for QoS policy condition clusters.
Admin
VIP/COND Status
128.241.130.204 Enabled
128.241.130.205 Enabled
128.241.130.206 Enabled
The name of the SLB cluster.
The virtual IP (VIP) address or the policy condition name for the SLB
cluster.
The administrative status of the SLB cluster (Enabled or Disabled).
The operational status of the SLB cluster; In Service (i.e., at least one
physical server is operational in the cluster) or Out of Service.
The total number of physical servers that belong to the SLB cluster. It is
possible to configure up 16 servers per cluster and up to 16 clusters per
switch. This allows a maximum of 256 physical servers per switch.
The percentage of flows successfully routed to the SLB cluster.
Server Load Balancing Commands
Operational
Status
In Service
In Service
Out of Service
OmniSwitch CLI Reference Guide
# %
Srv Avail
3 95
2 100
2 50
June 2012