Policy List - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

policy list

Configures a list of policy rules. There are two types of lists supported: User Network Profile (UNP) and

egress. Rules assigned to a UNP list are applied to traffic classified into a specific profile. Rules assigned

to an egress list are applied to traffic egressing on QoS ports.

policy list list_name type [unp | egress] rules rule_name [rule_name2...] [enable | disable]

no policy list list_name

policy list list_name no rules rule_name [rule_name2...]

Syntax Definitions

A default policy list is available when the switch boots up. This list has no name and is not configurable.

All QoS policy rules are assigned to this default list unless the no default-list option of the

command is used.

unp | egress

enable | disable

Platforms Supported

OmniSwitch 6400, 6850, 6850E, 6855, 9000E

OmniSwitch 6400, 6855-U24X, 9000E egress parameter supported.

Usage Guidelines

Use the no form of the command to remove a policy list from the configuration or to remove a policy

rule from an existing list.

The QoS policy rule name specified with this command must already exist in the switch configuration.

The name to assign to the policy list. Note that the list name is case

Applies the list of policy rules to the User Network Profile to which the

list is assigned.

Applies the list of policy rules to traffic egressing on QoS ports.

The name of an existing QoS policy rule to include in the policy list.

Optional. The name of another QoS policy rule to include in the policy

list. Separate each rule name specified with a space.

Enables the policy list.

Disables the policy list.

QoS Policy Commands

OmniSwitch CLI Reference Guide