Show Ip Dvmrp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

DVMRP Commands

show ip dvmrp

Displays the global DVMRP parameters.
show ip dvmrp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
N/A
Examples
-> show ip dvmrp
DVMRP Admin Status = enabled,
Flash Interval
Graft Timeout
Neighbor Interval
Neighbor Timeout
Prune Lifetime
Prune Timeout
Report Interval
Route Holddown
Route Timeout
Subord Default
Number of Routes
Number of Reachable Routes = 2
output definitions
DVMRP Admin Status
Flash Interval
OmniSwitch CLI Reference Guide
= 5,
= 5,
= 10,
= 35,
= 7200,
= 30,
= 60,
= 120,
= 140,
= true,
= 2,
The current global (i.e., switch-wide) status of DVMRP, which can be
enabled or disabled. To change the current DVMRP global status,
refer to the ip dvmrp status command on page
The current minimum flash update interval value, in seconds. The flash
interval defines how often routing table change messages are sent to
neighboring DVMRP routers. Because routing table change messages
are sent between the transmission of complete routing tables, the flash
update interval must be shorter than the route report interval. The
default value is 5.
June 2012
29-3.
page 29-25