Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1975

DVMRP Commands
output definitions
Interface Name
Vlan
Tunnel
Metric
Admin-Status
Oper-Status
Release History
Release 6.1; command was introduced.
Related Commands
ip dvmrp interface
MIB Objects
dvmrpInterfaceGroup
dvmrpInterfaceLocalAddress
dvmrpInterfaceMetric
dvmrpInterfaceStatus
OmniSwitch CLI Reference Guide
The name of the interface.
The associated VLAN ID.
Indicates whether there is a DVMRP tunnel currently configured on the
interface. This field is not relevant for Release 5.3.1 and later.
The current metric value. A metric is essentially used to determine the
most cost-effective way to pass data through the network. The higher
the metric value, the higher the cost.
The current administrative status of the corresponding interface.
Options include Enabled or Disabled. An interface can be configured
for DVMRP without being operational. To change the DVMRP
Admin-status for an individual interface, refer to the
ip dvmrp interface command on page
The current operational status of the corresponding multicast-capable
interface. Options include Enabled or Disabled. For an interface to be
DVMRP-operational, the global DVMRP status must be enabled and
the individual interface must be DVMRP-enabled. To change the
global DVMRP status, refer to the
page 29-3.
Enables or disables the DVMRP protocol on a specified interface.
June 2012
29-7.
ip dvmrp status command on
page 29-29