Ip Pim Register Checksum - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

PIM Commands

ip pim register checksum

Configures the application of the checksum function on sent and received register messages in the domain.
ip pim register checksum {header | full}
Syntax Definitions
header
full
Defaults
parameter
header | full
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The full option may be required for compatibility with older implementations of PIM-SM v2.
•
This parameter setting must be consistent across the PIM domain.
•
This command is supported only in the sparse mode.
Examples
-> ip pim register checksum header
-> ip pim register checksum full
Release History
Release 6.1.1; command was introduced.
Related Commands
show ip pim sparse
MIB Objects
alaPimsmGlobalConfig
alaPimsmOldRegisterMessageSupport
OmniSwitch CLI Reference Guide
Specifies that the checksum for registers is done only on the PIM
header.
Specifies that the checksum is done over the entire PIM register
message.
default
header
Displays the status of the various global parameters for the PIM
sparse mode.
June 2012 page 30-23