Show Ip Bgp Neighbors - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip bgp neighbors

Displays the configured IPv4 BGP peers.
show ip bgp neighbors [ip_address]
Syntax Definitions
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
There are two output options for this command. If you specify show ip bgp peer without a peer IP address,
then you see summary information for all peers known to the local BGP speaker. If you enter a specific
peer IP address with the command, then you see detailed parameter information for that peer only.
Examples
-> show ip bgp neighbors
Legends:Nbr = Neighbor
As = Autonomous System
Nbr address As
---------------+-----+-----------+------------+---------------+-----------
192.40.4.29
192.40.4.121
output definitions
Nbr address
As
Admin state
Oper state
BgpId
Up/Down
page 25-168
A 32-bit IP address.
Admin state Oper state
3 enabled estab
5 disabled idle
The IP address for this BGP peer. Assign this address through the
bgp neighbor
The autonomous system to which this peer belongs. A peer's AS num-
ber is assigned through the
Indicates whether this peer has been enabled or disabled through the
bgp neighbor status
The current BGP state for this peer. Possible states are idle, connect,
active, opensent, openconfirm, and established.
The unique BGP identifier of the peer. This value is configured
through the
The time since this peer has transitioned to its current UP or DOWN
state. If the peer is currently Established, then this is the time that the
peer has been UP. If the peer is currently Idle, then this is the time the
peer has been DOWN.
BgpId
192.40.4.29
0.0.0.0
command.
ip bgp neighbor remote-as
command.
ip bgp neighbor update-source
OmniSwitch CLI Reference Guide
BGP Commands
Up/Down
00h:14m:48s
00h:00m:00s
ip
command.
ip
command.
June 2012