Show Ip Pim Sgroute - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip pim sgroute

Displays all (S,G) state that the IPv4 PIM has.
show ip pim sgroute [source_address group_address]
Syntax Definitions
source_address
group_address
Defaults
By default, entire (S,G) routing table is displayed. To view the detailed information for a particular (S,G)
entry, use the source_address and group_address associated with that entry.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
When the source_address and group_address is specified in the command line, the detailed informa-
tion displayed also includes the detailed state of every outgoing interface.
•
If an IP address is not specified, the current PIM status for all multicast route entries are displayed.
Examples
-> show ip pim sgroute
Legend: Flags: D = Dense, S = Sparse, s = SSM Group,
L = Local, R = RPT, T = SPT, F = Register,
P = Pruned, O = Originator
Total 1 (S,G)
Source Address Group Address RPF Interface
--------------+-------------+--------------+-----------------+-----------+--------
172.21.63.2 225.0.0.0
172.21.63.2 225.0.0.1
-> show ip pim sgroute 172.21.63.2 225.0.0.0
(172.21.63.2,225.0.0.0)
UpTime
PIM Mode
Upstream Join State
Upstream RPT State
Upstream Join Timer
Upstream Neighbor
RPF Interface
RPF Next Hop
RPF Route Protocol
RPF Route Address
RPF Route Metric Pref
RPF Route Metric
page 30-70
The 32-bit IP address for a specific multicast source.
A 32-bit multicast address.
Upstream Neighbor UpTime
vlan-30 212.61.30.7
vlan-30 212.61.30.7
= 00h:02m:16s
= ASM,
= Joined,
= Not Pruned,
= 00h:00m:44s,
= 212.61.30.7,
= vlan-30,
= 212.61.30.7,
= OSPF,
= 172.21.63.0/24,
= 110,
= 2,
00h:02m:09s ST
00h:02m:09s ST
OmniSwitch CLI Reference Guide
PIM Commands
Flags
June 2012