Ipv6 Pim Static-Rp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

PIM Commands

ipv6 pim static-rp

Adds, modifies, or deletes a static RP for an IPv6 multicast group ("modifies" applies only to the RP
address, since the table is indexed from group address and prefix length parameters).
ipv6 pim static-rp group_address/prefix_length rp_address [[no] override] [priority priority]
no ipv6 pim static-rp group_address/prefix_length rp_address
Syntax Definitions
group_address
/prefix_length
rp_address
override
priority
Defaults
By default, the priority option is not set and the override option is set to false.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to delete a static RP configuration.
•
Specifying the priority value obsoletes the override option.
•
The IPv6 PIM Source-Specific Multicast (SSM) mode for the default SSM address range (FF3x::/32)
reserved by the Internet Assigned Numbers Authority is not enabled automatically and must be config-
ured manually to support SSM. You can also map additional IPv6 multicast address ranges for the
SSM group. However, the IPv6 multicast groups in the reserved address range can be mapped only to
the SSM mode.
•
If the group prefixes configured for two or more rows in this table overlap, the row with the greatest
prefix length value is used for the overlapping range
•
Note that once the priority option has been defined, a value of 65535 can be used to un-set the priority
•
This command is supported only in the sparse mode.
Examples
-> ipv6 pim static-rp ff0e::1234/128 2000::1 priority 10
-> no ipv6 pim static-rp ff0e::1234/128 2000::1
OmniSwitch CLI Reference Guide
Specifies the IPv6 multicast group address.
Specifies the prefix length of the IPv6 multicast group.
Specifies the IPv6 unicast address of the Rendezvous Point (RP). This
must be a domain-wide reachable address.
Specifies the static RP configuration to override the dynamically
learned RP information for the specified group(s).
Specifies the preference value to be used for this static RP configura-
tion and provides fine control over which configuration is overridden by
this static configuration. Values may range from 0 to 128.
June 2012 page 30-83