Fig 2-24 Tray 3 Feeder Assembly; Rrp 2-19Tray 3 Feeder Assembly (Pl 12.5) - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RRP 2-19Tray 3 Feeder Assembly (PL 12.5)

Fig 2-24 Tray 3 Feeder Assembly

Take care not to break or dislodge the No Paper Actuator when
Caution
removing or replacing the Tray 3 Feeder Assembly.
Removal
1.
Remove Tray 3 from the High Capacity Feeder.
2.
Remove the Rear Cover (RRP 2-2).
3.
Open the Left Door C Assembly.
4.
Remove the Spring that is located on the left side of the Inner Chute.
5.
Remove the two screws securing the Inner Chute to the High Capacity Feeder
frame, and remove the Inner Chute.
6. Remove the screw securing the Feed In Chute to the High Capacity Feeder
frame.
7.
Lift the Retard Shaft up and out of the way while you slide the Feed In Chute to
the front of the High Capacity Feeder.
8.
Push the Chute back and remove it from the frame.
9.
Remove Tray 3 Feed Clutch (RRP 2-13).
10.
Remove the E-ring that is securing the Feed Gear (located behind the Feed
Clutch) to the shaft, and remove the Feed Gear and Bearing.
11.
Hold down the Stopper Link while you pull the Feeder Assembly to the front of
the High Capacity Feeder frame.
12.
Remove the Feeder Assembly from Feeder 3.
Volume 2 / High Capacity Feeder - RRPs
S4525-213
2-437