Rep 1.1 Document Catch Tray Assembly; Rep 1.2 Rh Cover - Xerox Telecopier 7017 Technical Reference Manual

REP 1.1 Document Catch Tray
Assembly
Parts List on PL 1.1
Removal
Pull document catch tray assembly straight
forward to remove.
Replacement
1. Align positioning slots
catch tray assembly
channels on base plate.
2. Press firmly towards the rear to secure.
Telecopier 7017 / 7017SF

REP 1.2 RH Cover

Parts List on PL 1.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Open printer.
on document 4. Open and secure scanner.
with the two
Do not bump the scanner after it is secured.
The scan support assembly will release and
cause the upper scan assembly to pinch you.
5. Remove RH cover.
NOTE: Use the cutout in the RH cover to
access and release the center latch.
a. Release the three latches (Figure 1)
from the base plate.
NOTE: Machines with serial numbers
(TBD) and above do not have the
center latch.
b. Remove the two screws securing the
RH cover to the RH frame.
c. Slide RH cover towards the right to
clear the upper scan cover and the
base plate, then pull it up and
towards the rear to clear the A8 store
& forward PWB, if installed.
WARNING
12/88
4-3
www.printcopy.info
Replacement
Reinstall in reverse order.
REP 1.1, 1.2