Replacement
1.
To install, carry out the removal steps in reverse order taking note of the following:
NOTE: Ensure the tip of the Staple Assembly is inserted into the hole in the bracket. (Fig-
ure 3)
Figure 3 Installing the Staple Assembly
Reversion 4.0
WorkCentre 7132
REP 16.9.1 Compiler Tray Assembly
Parts List on PL 17.9
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Check that "Ready to Copy" is displayed on the Control Panel display.
1.
Remove the Staple Assembly (REP 16.8.2).
2.
Remove the Tray Guide (Perform REP 16.5.2 up to Step 5.)
3.
Release the clamp to remove the wire. (Figure 1)
1.
Disconnect the connectors (x2).
2.
Release the Edge Saddles (x2) to remove the wire.
Figure 1 Disconnecting the connectors
January 2007
4-177
WARNING
CAUTION
Repairs/Adjustments
REP 16.8.2, REP 16.9.1