Edge Node Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – RRPP
H3C S5500-EI Series Ethernet Switches
Enable the subring
Return to system view
Enable RRPP
Caution:
The control VLAN configured for an RRPP domain must be a new one.
Control VLAN configuration is required for configuring an RRPP ring.
A Ring ID cannot be applied to more than one RRPP ring in an RRPP domain.
You must first configure the primary ring and then the subring when configuring an
edge node. Moreover, you must remove all subring configurations before deleting
the primary ring configuration of an edge node. However, the RRPP ring enabled
cannot be deleted.
To use the undo rrpp domain command to remove an RRPP domain, you must
ensure the RRPP domain has no RRPP ring.

1.5.2 Edge Node Configuration Example

I. Networking requirements
Specify the device in RRPP domain 1;
Set VLAN 4092 as the control VLAN;
Specify the device as the transit node of primary ring 1 in RRPP domain 1,
GigabitEthernet 1/0/1 as the primary port and GigabitEthernet 1/0/2 as the
secondary port;
Specify the device as the edge node of subring 2 in RRPP domain 1,
GigabitEthernet 1/0/2 as a common port and GigabitEthernet 1/0/4 as an edge
port.
II. Configuration procedure
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] link-delay 0
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface gigabitethernet 1/0/2
To do...
ring ring-id enable
quit
rrpp enable
Use the command...
1-15
Chapter 1 RRPP Configuration
Remarks
Required
By default, the RRPP ring
is disabled.
—
Required
By default, RRPP is
disabled.