Installation Manual
H3C S7502 Ethernet Switch
Step 6: Type <Y> to start file downloading or <N> to return to the program downloading
menu. Suppose you type <Y>. The system starts Boot ROM program downloading and
upon its completion automatically starts Boot ROM loading. The system displays the
following information upon the completion of the entire process:
Prepare for loading...OK!
Loading....................................................done!
SRPU bootrom is updating now......
Get flash Type......FLASH_M29W040B
Erasing flash......done!
Programming flash......done!
Checking flash......done!
III. Loading host software
Follow these steps to download the host software of the switch:
Step 1: Select <1> from Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
The subsequent steps are the same as those for loading Boot ROM, except for the
messages displayed.
7.2.4 Loading Software from the Management and Upgrade Ethernet Port Using
FTP
I. Introduction to FTP
A switch can be used through Ethernet port as an FTP server or a client to provide
another approach to software loading and file configuration.
In the following example, the switch functions as an FTP client.
II. Loading SRPU Boot ROM
Step 1: Connect the switch to the PC, which saves the file to be downloaded, through
the management and upgrade Ethernet port. The IP address of the PC is required. The
IP address of the PC is required. Connect the switch to another PC through the
Console port. The two PCs can be the same one.
Step 2: Run the FTP Server program on the PC connected to the Ethernet port, and
specify the path for program loading.
Chapter 7 Software Maintenance
7-10