Console Port Login Configuration With Authentication Mode Being Password; Configuration Procedure - H3C S3100 Series Operation Manual

After the above configuration, you need to modify the configuration of the terminal emulation utility
running on the PC accordingly in the dialog box shown in
Console Port Login Configuration with Authentication Mode Being
Password

Configuration Procedure

Table 2-5 Console port login configuration with the authentication mode being password
Operation
Enter system view
Enter AUX user interface view
Configure to authenticate users
using the local password
Set the local password
Configure the
Console port
Configure the command level
available to users logging into
the user interface
Make terminal services available
to the user interface
Set the maximum number of
lines the screen can contain
Set history command buffer size
system-view
user-interface aux 0
authentication-mode
password
set
password
simple } password
Set the baud
speed speed-value
rate
Set the check
parity { even | none | odd }
mode
Set the stop
stopbits { 1 | 1.5 | 2 }
bits
Set the data
databits { 7 | 8 }
bits
user privilege level level
shell
screen-length
screen-length
history-command
max-size value
Figure 2-4
Command
—
—
Required
By default, users logging into a switch
through
authenticated; while those logging in
through
authenticated.
authentication
{ cipher | Required
Optional
The default baud rate of an AUX port (also
the Console port) is 9,600 bps.
Optional
By default, the check mode of a Console
port is set to none, that is, no check bit.
Optional
The default stop bits of a Console port is 1.
Optional
The default data bits of a Console port is 8.
Optional
By default, commands of level 3 are
available to users logging into the AUX user
interface.
Optional
By default, terminal services are available
in all user interfaces.
Optional
By default, the screen can contain up to 24
lines.
You
command to disable the function to display
information in pages.
Optional
The default history command buffer size is
10. That is, a history command buffer can
store up to 10 commands by default.
2-8
to log into the switch successfully.
Description
the Console port
Modems or Telnet
can use the screen-length
are not
are
0