Troubleshooting Ipx Configuration; Troubleshooting Ipx Forwarding Failure - H3C MSR3600-51F Configuration Manual

[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] ipx network 2
# Set the packet encapsulation format on the Ethernet interface to Ethernet_II.
[RouterA-Ethernet1/2] ipx encapsulation ethernet-2
[RouterA-Ethernet1/2] quit
# Enable IPX on the interface Ethernet 1/1, with the network ID being 1000.
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ipx network 1000
[RouterA-Ethernet1/1] quit
2. Configure Router B:
# Enable IPX.
<RouterB> system-view
[RouterB] ipx enable
# Enable IPX on the interface Ethernet 1/2, with the network ID being 3.
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] ipx network 3
# Set the packet encapsulation format on the Ethernet interface to Ethernet_SNAP.
[RouterB-Ethernet1/2] ipx encapsulation snap
[RouterB-Ethernet1/2] quit
# Enable IPX on the interface Ethernet 1/1, with the network ID being 1001.
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ipx network 1001
[RouterB-Ethernet1/1] quit
# Configure a Server file service information item.
[RouterB] ipx service 4 server 2.0000-0c91-f61f 451 hop 2
# Configure a Server print service information item.
[RouterB] ipx service 26B tree 2.0000-0c91-f61f 5 hop 2
RIP and SAP are automatically enabled when the ipx network command is issued on an IPX
interface. Therefore, in this example, no routing protocol is configured.

Troubleshooting IPX configuration

Troubleshooting IPX forwarding failure

IPX cannot go up on a PPP link
•
Confirm whether network IDs of both ends of the link are the same. Reconfigure them if they are
different.
•
Confirm whether node IDs of both ends of the link are different. Reconfigure them if they are the
same.
Failed to ping a destination address
•
Confirm whether the destination address is correct.
•
Use the display ipx interface command to check the interface configuration. The network ID
and IPX frame encapsulation format on the directly connected interfaces must be the same.
•
Use the display ipx routing-table command to display routing information. Check whether a
route to the destination network is available.
10