Mpls Te Configuration Examples; Mpls Te Using Static Cr-Lsp Configuration Example - H3C S5500-HI Series Mpls Configuration Manual

Task
Display statistics about TE for IS-IS.
Display information about tunnels.
Display the BFD information for an
MPLS TE tunnel.
Display information about the
specified tunnels and their
protection tunnels.
Clear the statistics about RSVP-TE.

MPLS TE configuration examples

MPLS TE using static CR-LSP configuration example

Network requirements
• Switch A, Switch B, and Switch C run IS-IS.
Establish a TE tunnel using a static CR-LSP between Switch A and Switch C.
•
Figure 31 Network diagram
Vlan-int1
2.1.1.2/24
Vlan-int1
2.1.1.1/24
Switch A
Loop0
1.1.1.1/32
Configuration procedure
Assign IP addresses and masks to interfaces (see
1.
Command
display isis traffic-eng statistics
[ process-id | vpn-instance
vpn-instance-name ] [ | { begin |
exclude | include }
regular-expression ]
display tunnel-info { tunnel-id | all
| statistics } [ | { begin | exclude |
include } regular-expression ]
display mpls lsp bfd [ te tunnel
tunnel-number ] [ | { begin |
exclude | include }
regular-expression ]
display mpls te protection tunnel
{ tunnel-id | all } [ verbose ] [ |
{ begin | exclude | include }
regular-expression ]
reset mpls rsvp-te statistics { global
| interface [ interface-type
interface-number ]
Loop0
2.2.2.2/32
Vlan-int2
3.2.1.1/24
Switch B
Vlan-int2
3.2.1.2/24
Switch C
Loop0
3.3.3.3/32
Figure 31.) (Details not shown.)
128
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view