Displaying And Maintaining Static Routes; Static Route Configuration Example - H3C S3100-52P Operation Manual

Operation Manual – Static Route
H3C S3100-52P Ethernet Switch
Note:
Use the ip route-static command to configure a default route by setting the
destination IP address and the mask to 0.0.0.0.
Avoid configuring the next hop address of a static route to the address of an
interface on the local switch.
Different preferences can be configured to implement flexible route management
policies.

2.3 Displaying and Maintaining Static Routes

Display the current
configuration information
Display the brief information of
a routing table
Display the detailed
information of a routing table
Display the information of
static routes
Delete all static routes

2.4 Static Route Configuration Example

I. Network requirements
A small company requires that any two nodes in its office network communicate with
each other, and that the network structure be simple and stable. The company hopes
that the existing devices that do not support any dynamic routing protocol can be fully
utilized.
In this case, static routes can implement communication between any two nodes.
II. Network diagram
According to the network requirements, the network topology is designed as shown in
Figure 2-1.
To do...
Chapter 2 Static Route Configuration
Use the command...
display current-configuration
display ip routing-table
display ip routing-table verbose
display ip routing-table protocol
static [ inactive | verbose ]
delete static-routes all
2-3
Remarks
Available in
any view
Available in
system view