Connecting The Usb Console Port By Using A Usb Cable; Setting Terminal Parameters - H3C SR6604 Installation Manual

Figure5-3 Finishing the driver installation
6. Connect the standard USB connector of the cable to the USB port of the configuration terminal.
7. Connect the RJ-45 connector of the cable to the console port of the router.

Connecting the USB console port by using a USB cable

IMPORTANT:
After using a USB console cable to connect the router to a configuration terminal, you must
download and install the USB console driver program from
the device.
To use a USB console cable to connect the router to a configuration terminal:
1. Click the following link, or copy it to the address bar of the browser to log in to the download
page of the USB console driver, and download the driver.
https://www.h3c.com/cn/Home/QR/USBControl.htm
2. Run Installer to pre-install the driver. A message that indicates successful driver pre-installation
will pop up when the preinstallation is complete.
3. Connect the standard USB port of the USB cable to the configuration terminal.
4. Connect the mini USB port at the other end of the USB cable to the USB console port on the
router. Then, the system will install the driver automatically.

Setting terminal parameters

To configure and manage the router through the console port, you must run a terminal emulator
program, TeraTermPro or PuTTY, on your configuration terminal. You can use the emulator program
to connect a network device, a Telnet site, or an SSH site. For more information about the terminal
emulator programs, see the user guides for these programs.
http://www.h3c.com/
54
before configuring