Displaying And Maintaining Basic Port Configuration; Ethernet Port Configuration Example - H3C S3100-52P Operation Manual

Operation Manual – Port Basic Configuration
H3C S3100-52P Ethernet Switch

1.1.14 Displaying and Maintaining Basic Port Configuration

Display port
configuration
information
Display the
enable/disable status
of port loopback
detection
Display brief
information about port
configuration
Display port
information about a
specified unit
Display the storm
control configurations.
Display the statistics
on the packets
dropped on a port or all
ports
Display the information
about the port with the
link-delay command
configured
Clear the statistics on
packets dropped on a
port or all ports
Clear port statistics

1.2 Ethernet Port Configuration Example

I. Network requirements
Switch A and Switch B are connected to each other through two trunk port
(Ethernet 1/0/1).
To do...
display interface [ interface-type
| interface-type interface-number ]
display loopback-detection
display brief interface
[ interface-type
[ interface-number ] ] [ | { begin |
include | exclude }
regular-expression ]
display unit unit-id interface
display storm-constrain
[ interface interface-type
interface-number ] [ | { begin |
exclude | include }
regular-expression ]
display packet-drop { interface
[ interface-type interface-number ]
| summary }
display link-delay
reset packet-drop interface
[ interface-type interface-number ]
reset counters interface
[ interface-type | interface-type
interface-number ]
Chapter 1 Port Basic Configuration
Use the command...
1-12
Remarks
Available in any view
Available in user view
Available in user view
After 802.1x is
enabled on a port,
clearing the statistics
on the port will not
work.