Triumph TR6 PI Operation Manual page 73

SPIGOT BUSH
- Remove and refit
12.21.45
Removing
1. Remove the flywheel 12.53.07.
2. From the back of the flywheel remove the spigot
bush.
Refitting
3. Fit the spigot bush into the back of the flywheel
ensuring that it is a loose fit.
4. Refit the flywheel- instruction 8 to 14, 12.53.07.
CYUNDER PRESSURES
ENGINE
NT2
.u
DATA
All cylinders should have pressures within 10 lb/in
2
(0'70 kg/cm
2
)
of each other.
1. Start and run the engine until the normal operating
temperature is attained as indicated by the
temperature gauge on the control panel.
2. Stop the engine and remove the spark plugs.
3. Fit a compression gauge to number one cylinder.
4. Tum the engine over with the starter motor only with
the throttles wide open.
5. Record the gauge reading - See DATA.
6. Repeat instructions 3 to 5 on the remaining.cylinders.
7. Remove the gauge and refit the spark plugs.
-Check
12.25.01
Triumph TR6 Manual. Pan No. S4S271 Issue 1
12.21.45
12.25.01