Triumph TR6 PI Operation Manual page 461

ELECTRICAL
HORN SLIP RING
- Remove and refit 86.30.02
Removing
1. Perform 86.65.17 operations 1 to 5.
2.
Disconnect one snap connector.
3. Remove the horn push 86.65.18.
4. Remove the steering wheel 57.60.01.
5.
Bend up two metal tags. Remove the slip ring with its
wire.
Refitting
6. Thread the wire through the appropriate steering
column apertures, fascia panel aperture and steering
column clamp aperture. Do not disturb the position
of the felt strip located below th~ wires in the lower
half of the steering column clamp. Position the slip
ring and secure by bending down two metal tags.
Note that two spare metal tags are provided for use if
one of the original tags should break..
7. Apply petroleum jelly (Vaseline) to the slip ring
contact surface.
8. Fit the steering wheel 57.60.01
9. Fit the hom push 8'6.65.18.
10. Ensure that the felt strip is correctly located and
rectify if necessary .
11. Connect one snap connector. Purple/black slip ring
wire to purple/black main harness wire.
12. Perfrom 86.65.17 operations 14 to 18.
86.30.02
Triumph TR6 ManuaL Part No. 545277 Issue I