Triumph TR6 PI Operation Manual page 415

Removing
I. Use a pair of pliers to grip the metal jet nozzle and
carefully pull it from the rubber moulding.
2. Remove the wheelbox spindle nut.
3. Carefully break the seal between the rubber moulding
and vehicle body.
4.
Carefully withdraw the rubber moulding. Ensure that
the plastic tube is not detached from the metal pipe
and lost in the body wheelbox cavity as retrieval may
be difficult.
5. Pull
the plastic tube from the metal pipe.
WINSCREEN WASHER JET
- Remove and refit 84.10.09
WINDSCREEN WIPERS AND WASHERS
Refitting
6. Reverse instructions 1 to 5. Seal the rubber moulding'
to the vehicle body using an approved sealer.
WINDSCREEN WASHER PUMP AND RESERVOIR
NT0651
- Remove and refit
Removing
84.10.21
1. Disconnect two Luear connectors.
2. Early vehicles with Lucas 5SJ unit only - pull off the
outlet pipe.
3. Later vehicles with
Lucas
9SJ unit only - remove the
cover.
Pull
off the'outlet pipe and withdraw it from
the cover. Refit the cover.
4. Manoeuvre the unit upwards from the earrier.
Refitting
5. Reverse instructions 1 to 4. To ensure that the motor
runs in the correct direction observe polarity. Connect
the Lucar connectors as follows:
Ught green/black wire to the. positive terminal.
Black wire to the negative terminal.
Triumph TR6 Manual. Part No. S4S277 IsSue I
84.10.09
84.10.21