Triumph TR6 PI Operation Manual page 188

FUEL SYSTEM - TC
CARBURElTERS COMPLETE WITH INLET MANIFOLD
Refitting
12. Clean the manifold mating faces and offer up and
secure the manifold to the cylinder head with the
three nuts and spring washers and the six nuts and
plain washers.
NOTE: If the manifold gasket is in any way damaged it
should be replaced 30.15.01.
13. Reverse instructions I to 9.
Removing
1. Remove the air cleaner 19.10.01.
2. Disconnect the mixture control cables from both
carburetters.
3. Disconnect the emission pipes from the carburetters
and rocker cover.
4. Disconnect the vacuum pipe at the rear carburetter to
the thermo static vacuum switch.
5. Disconnect the main fuel supply pipe to the
carburetters.
6. Disconnect the throttle linkage at the countershaft.
7.
Partially drain the cooling system.
8. Disconnect brake servo vacuum hose at the iniet
manifold.
9.
Disconnect the manifold heater hoses at the front and
rear of the manifold.
10. Remove the three nuts and spring washers securing
the inlet manifold to the cylinder head and the six
nuts and plain washers securing the inlet and exhaust
manifold to the cylinder head.
11. Withdraw the carburetters complete with the inlet
manifold.
4
19.15.15
- Remove and refit
Triumph TR6 Manual. Part No. 545277 Issue 1
19.IS.ISC