Table of Contents
Advertisement
FUEL SYSTEM -
PI
FUEL PUMP
- Remove and refit
19.45.08
Removing
1.
Open the luggage boot lid.
2.
Remove the floor carpeL
3.
Remove the spare wheel cover panel.
4.
Remove two screws securing the luggage boot lamp.
S.
Withdraw the lamp assembly from the petrol tank
trim panel.
6.
Disconnect two Lucar connectors.
7.
Remove eight screws and washers and withdraw the
petrol tank trim panel.
8.
Isolate the battery.
9.
Disconnect two snap connectors.
10.
Pull the drain pipe upwards from the body aperture
grommet and then pull from fuel pump pipe.
11.
Prepare for fuel spillage. Disconnect the inlet pipe
coupling and the outlet pipe coupling.
12.
Under wheel arch. remove three nuts and spring
washers. Three plain washers may remain stuck to the
body undersea!.
13.
Withdraw the fuel pump from its mounting.
14.
Unscrew three special rubber mounting studs.
Refitting
15.
Reverse instructions 10 to 14.
16.
Connect two snap connectors observing polarity to
ensure that the pump motor runs in the correct
direction.
17.
Connect the battery.
18.
Turn on ignition to energise the fuel pump. Check the
disturbed fuel pipe couplings to ensure no fuel
leakage.
19.
Reverse instructions 1 to 7.
19.45.08 P.I.
Triumph TR6 Manual. Pan
No. 545277 Issue 1
Hide quick links:
Advertisement
Table of Contents
